Car brakes Failure is a common car issue that when not handled appropriately or when not handled in time can cause damage to the car and can even cause unwanted accidents. Brakes practically are mechanical devices that retards motion just by generating energy from a moving system.
The brake is usually used to slow down or stop a vehicle that is moving, axle, wheel in order to put a halt to its motion. This is mostly executed by a means of friction.
You don’t need to wait for your car to break down before you find solutions to it. The reason is that car break failure causes damages to a car especially when involved in an accident. Not only the car, but it can also cause harm to the health of the drivers as well as passengers when involved in an accident.
Like I mentioned earlier, The brake is usually used to slow down or stop a vehicle that is moving, axle, wheel in order to put a halt to its motion. So, if the brake is not properly inspected before embarking on a journey or before moving a car, the end result might not be funny and can take the lives of people.
So, I will advise that before you start up your car or embark on any journey, always practice what I call brake inspection. And what is a brake inspection?
Types of Car brakes
Car brakes are the most important thing you should check before starting your car so as to be on a safer side. Also, you should know the type of brake your car experiences at that moment so as to get the perfect solution.
Well, there are basically 4 types of car brakes, and they include:
- Disc Brakes
- Drum Brakes
- Emergency Brakes and
- Anti-Lock Brakes
Disc brakes and drum brakes are known as “service brakes”. They are typically the kind of brakes that stops your vehicle while driving. While emergency brake and anti-lock brakes usually come with vehicles when purchased.
What is a brake inspection?
Practically, you can refer the brake system inspection to as the very first line of defense or inspection being carried out on a car before starting a car so as to place the stopping power of your vehicle at optimal performance.
However, a car brake inspection can also be defined as a must-do inspection to make sure that driving is in a safe condition. Below are what you need to check to proceed brake inspection. To proceed brake inspection, you must check your brake:
- rotors (and/or drums)
- wheel bearings and grease seals
- pads (and/or shoes)
- master cylinder fluid exchange
- fluid condition
- hardware (springs and adjusters)
- parking brake cables
- wheel cylinders
What do I do when my car brake fails?
Now that you have understood what the car brake is all about, you can now carefully follow the steps below to know what to do when your car break fails. Here is what to do when your car break fails:
- As soon as you notice brake failure, hasten up! and pump your brakes to try using any residual pressure in the brake.
- The next step to take is to remove your foot from the gas pedal – try to move to a lower gear. Allow the wind resistance as well as the drive train friction to slow down your vehicle.
- Now make use of your emergency brake (As I said earlier, emergency brake comes with the vehicle once purchased). Make use of your emergency brake to control the brakes if possible. If you have got an emergency brake handle, place the button on the end pressed down.
- The reason is so the wheels don’t lock up. If you really do not know how the emergency brake works or how to use it, then and then should you reach out for your OWNER’S MANUAL.
- Finally, find something to rub against. Be it a guardrail, bushes, or a fence, either of them would work. Now, try picking up something that will take away when you hit against it. To lessen the damage that would be inflated on you and in your car too. As soon as the car stops, never ever drive it again, until you properly fix the brake.